Network configuration

Technology, Literature and the Rest

Configuring multiple public DHCP IP addresses on a Linksys WRT54G with OpenWrt
These parameters are handled partially by netifd in interface. Also, once you set a password in OpenWrt, telnet will no longer functions see above. There is no preset password in OpenWrt! The following example was done with PuTTY. Seconds to wait before trying to interact with the modem some modems require up to 30 s.

4 thoughts on “Configuring multiple public DHCP IP addresses on a Linksys WRT54G with OpenWrt”

OpenWrt – First Login

By clicking "Post Your Answer", you acknowledge that you have read our updated terms of service , privacy policy and cookie policy , and that your continued use of the website is subject to these policies. Home Questions Tags Users Unanswered. I tried the following without success: Do you mean that you enter the public static IP information in your PC instead of your router? There are a few things that don't seem right.

Also consider clarifying what it means to do something without success. Does it mean that the router does not accept your configuration or that your PC has no Internet access?

I'm not sure I get you right here. At my PC, I have to set these configurations to connect to the internet via ethernet provided by my student's appartement. Nothing about an ethernet address I guess. When I try to transfer these settings to the Onion Omega2 by setting the wan interface in the network file, it doesn't connect to the internet no successful ping.

Is your PC the Omega2 or the Omega2 is your router? If it is the router, can you log on to it to check if it has network access? Your setup is unclear and I would have a ton of things to ask to troubleshoot an issue that I'd solve in 5 minutes if I was there.

Make sure your browser accepts session cookies. LuCI login fails if password is set and session cookies cannot be accessed.

Then click on the left in the top bar on Administration , then go to System in the bar underneath. A page to change the password is displayed. Write your desired password into the field Password and repeat it in the field Confirmation. Open your browser and connect to the router at its default address usually http: Login using username root and with the password that you have previously set up by CLI follow the steps in "Login with telnet" part in this web page. Open your browser and connect to the Web Interface at its default address You can ssh to the router at the default address Unlike OpenWrt the telnet port is not open.

If you encounter problems with login, i. If you have any firewalls, you may disable them. Also, once you set a password in OpenWrt, telnet will no longer functions see above. Try again after a minute or two. On the first bootup OpenWrt will be busy setting up the filesystem and generating SSH keys; the SSH server won't start until after the keys have been generated. Once you've set a password new telnet connections are immediately terminated. You must SSH at that point.

User Tools Register Log In. This wiki is read only and for archival purposes only. First connection to Luci to set up password for root account by GUI. First connection to Luci after set up password for root account by CLI. Telnet connection immediately closes.

Your Answer